Surly Cheater Bar Black
Description
The Cheater Bar is built from triple butted 4130 Chromoly steel and is tough enough to handle all of the abuse you will inflict upon it on the trail.
Bar Clamp Diameter (mm): 31.8 mm
Width: 780 mm
Rise: 0 mm
Back Sweep (deg): 11 deg
Upsweep: 0
Weight: 427 g
Material: Chromoly Steel
Webshops and Bike shops
You may also be interested in...
-
Stock Code:SMHB27658
A super wide cousin of the Sparrow designed for offroad use. Inspired by the sweep angle of the Jeff Jones H-Bar. The Clarence makes it easy to throw the bike around in technical situations. Plus the grip position feels really natural. The 31.8mm version is slightly wider than the 25.4mm.
- 6061-T6 aluminum
- 34° back sweep
- 19° upsweep
- 37mm rise
- 670mm width
- 31.8mm center
- 22.2mm ends$175.00 (RRP) -
Stock Code:WMHB-HS-4Stock Code:WMHB-HS-5$32.00 (RRP)$32.00 (RRP)
-
Stock Code:SLHB-HB2695
The Terminal Bar blends cruiser-style comfort with off-road touring performance. Able to run with a 40mm drop or rise, its swept-back design makes it great for long rides on rough, technical terrain.
Back Sweep (deg): 34 deg
Bar Clamp Diameter (mm): 31.8 mm
Weight: 400 g
Lever Compatability: Mountain 22.2
Material: Aluminum
Rise: 40 mm
Width: 735 mmPOA -
Stock Code:SMHB27098
Here is your alternative to "alternative drop bars". It's wide and takes MTB grips as well as bar tape. The grip area is long; long enough to run grip shifters (including Rohloff) and flat bar levers. But the Gator will also take aero levers just like the Junebug. Try it bikecamping, offroading, or touring.
- 6061 butted aluminum
- Width: 655mm at ends, center-to-center
- Width: 505mm at front of drops, center-to-center
- Width of flats on top: 340mm
- Center: 31.8mm
- Drops flare out at 20° angle
- Drops are 190mm long and have an OD of 22.2 (i.e. they can take flat bar grips)
- Reach: 65mm / Drop: 112-160mm
(Reach and drop is relative to the angle you install these bars at. On these types of bars, you want to angle the drops down, not have them parallel to the ground as with road bars)
- Weight: 400g
- No cable grooves
- Shotpeen finish$214.00 (RRP) -
Stock Code:SMHB280143
If you find your current bars were cut too short or designed too short to fit your brake lever and shifter set up, check these out.
Attach these to your bar ends to add 50mm (2") to each side of your bar. Also useful if you want to your cruiser bars to reach back a little farther.
- For city/MTB bars with 22.2mm OD.
- Aluminum constuction
- 50mm of extension per unit
- The resulting fit is not perfectly seamless, but good enough to where it should feel normal after grips are installed.
- DO NOT use on bars that have been partially machined out at the ends (to fit bar end shifters or reverse levers) This includes Soma Oxford, Sparrow and 3-speed II bars
- ID not sized to accept reverse levers or bar end shifters.
- Requires a 6mm hex key (2 inches long) to install$47.00 (RRP)
