Tanaka Half Basket Stainless Steel Raw
Description
Stainless steel wire basket great for mounting to a front or rear rack. 15" x 10" x 2-3/8"
Low profile for lighter weight and less likely to cause interference with lower set handlebars.
Webshops and Bike shops
You may also be interested in...
-
Stock Code:NTRK-NFM18
This rack is designed for light loads, or to support a handlebar bag.
-Hand-brazed from Chromoly
-Mounts to most bikes with drilled fork crown and incorporates with the caliper brake
-Compatible with some forks that feature mid-blade braze-ons dependent upon braze-on position
-Comes with additional set of braze-ons
-Lower rack struts are 235mm at max extension
-Rack surface area: 19cm x 11cm / Weight: 340g$228.00 (RRP)Add To Cart
-
Stock Code:SLRK-RK0102Stock Code:SLRK-RK0103
The rear Rack is also height-adjustable, enabling it to fit a wide variety wheel sizes while allowing you to move its center of gravity as low as possible for a more stable ride. Its wide platform has plenty of room for rack trunks, sleeping bags, tents, boxes of lima beans, or small cages full of hamsters. The stainless steel hardware we provide will enable you to fit them to most rigid 26" and 700c frames, and to forks equipped with drum, caliper, or cantilever brakes. Disc brakes and suspension are generally not compatible with our rear Racks, though there is an increasing number of frames designed to allow the use of racks and disc brakes.
Our rear rack will fit on a Pugsley/Moonlander, though it will sit slightly off-center due to the frame's offset design , and it sits a bit higher than normal since the mounts are part of the way up the seat stays rather than right at the dropouts like usual (this is to allow disc brake clearance). This is not something that will greatly affect the performance of the rack, but if you notice it try playing around with how you have your weight distributed on the rack until it feels "normal".
Rear rack WILL work with disc brakes on our Troll, Ogre, ECR, and Disc Trucker framePOAPOA -
Stock Code:SMRK185710
Front mini rack with a host of braze-ons for your gadgets. This one has wider-set stays to fit gravel forks like the Enve Adventure series.
Extra long tang is bent for mounting to caliper brake bolt.
P-Clamps and other hardware included.
If installing to a braze-on, the braze-on need to be about 140mm from the brake hole on the crown. If your braze-on is too low, you will need to install using P-clamps on the legs.Expected Date:18 August 2025$249.00 (RRP) -
Stock Code:SLRK-RK0104
Replacement Surly Bicycle Mounted Rack Parts
- Direct replacement item for Surly racks
- Replacement upper tubes, made from Stainless steel
- For upper mounts on rear rack onlyPOA
